Step 2 Adjust Leveling Legs; Step 3 Remove Toekick; Step 4 Install Power Cord; Step 5, Install 90° Elbow - GE Monogram ZBD1870 Installation Instructions Manual

Installation Instructions
STEP 2 ADJUST LEVELING LEGS
Hove the dishwasher close to the installation location and lag
it on its back.
Adjustto
Installation
Height
O
Figure L
Measure installation height and dishwasher height. Extend
leveling legs out from the dishwasher base, 1/2" less than
installation height.
STEP 3 REMOVE TOEKICK
• Remove the 4 toekick screws. Lift off the 2 piece toekick.
Figure M
STEP 4 INSTALL POWER CORD
Skip this step if dishwesher will be direct wired.
Use Power Cord Kit WX09X70910, available for purchase
from an authorized GEAppliance Dealer. The power cord and
connections must complg with the National Electrical Code,
Section 422 and/or local codes and ordinances.
Maximum power cord length is 6'.
A B CheckThat White, Blackand
Remove Green DishwasherWiresAre Threaded
Junction Box Thru Holein Back
Cover
Ground I
D UseULListed
Wire Nuts
Figure N
/ White
C
InsertPower
CordWiresThru
StrainRelief
and Tighten
Connect incoming power cord white (or ribbed) to dishwasher
white, black (or smooth) to black and ground to dishwasher
green wire. Use UL listed wire nuts of appropriate size.
Replace junction box cover. Be sure wires are not pinched
under the cover.
STEP 5 INSTALL 90 ° ELBOW
• Wrap 90° elbow with thread seal tape.
Install a 90 ° elbow onto the water valve.
Fill
Hose
90 °
Elbow
\
Thread
Seal Tape
Figure O
Water
Valve
Bracket
Do not over tighten 90 ° elbow, water valve bracket could
bend or water valve fitting could break.
Position the end of the elbow to face the rear of the
dishwasher.