Step 10 Push Dishwasher Into Final Position; Step 11 Level Dishwasher - GE Built-In Dishwasher Installation Instructions Manual

Installation Instructions
STEP 10 PUSH DISHWASHER INTO
FINAL POSITION
Tip: Check tub insulation blanket, if equipped. It should be
positioned so it is not "bunched up" or interfering with door
springs. Check by opening and closing door.
• Push dishwasher into the cabinet. The edges of the
dishwasher door should be behind the cabinet frame and
evenly aligned with the front face of cabinet doors.
• Carefully open and close the door to ensure the door panel is
not catching or rubbing on the cabinet frame.
����
��������
������
����
������
�������
�����
�������
���������
Figure R
���������
8
������������
����������������
�������������������
��������������
�����������

STEP 11 LEVEL DISHWASHER

IMPORTANT
– Dishwasher must be level
for proper dish rack operation and wash performance.
• Place level on door and rack track as shown. Check to make
sure that the dishwasher is level.
Check
Level
Front-
to-Back
Figure S
923-02Y
• Level the dishwasher by adjusting the four leveling legs
individually.
• If adjustment to the right rear leveling leg is required, loosen
junction box bracket screw (through the access hole) and
rotate bracket clockwise to provide additional access.
Tip: Pull lower rack out, about halfway. Check to be
sure the rack does not roll forward or back into
dishwasher. If the rack rolls in either direction, the
dishwasher must be leveled again.
• If door hits tub, the dishwasher is not installed correctly.
Adjust leveling legs to align door to tub.
J. Box Access Hole
Turn Legs
to Adjust
Figure T
923-02AA
Check
Level
Side-
to-Side