Choosing A Location And Setting Up The Device - Fujitsu Siemens Computers Primergy Econel 100 Series Operating Manual

Choosing a location and setting up the device

Videoworkstation Device, Ergonomic
When installing your device, please read the recommendations and
safety notes in the "Safety" manual.
Set up the device only in its correct orientation (vertical position).
We recommend that you place your device on a surface with good anti-slip qualities.
In view of the multitude of different finishes and varnishes used on furniture, it is
possible that the rubber feet will mark the surface they stand on.
Do not stack several devices on top of each other.
Depending on the location of your device, bothersome vibrations and noises may
occur. To prevent this, a distance of at least 3 mm should be maintained from other
devices on casing sides without ventilation surfaces. In addition, we recommend
placing the device on support feet, as these buffer vibrations.
Make sure that the device is adequately ventilated. In order to avoid overheating,
do not cover the ventilation area of the monitor or the device.
Do not expose the device to extreme ambient conditions (see
61, "Ambient conditions"). Protect the device from dust, humidity, and heat.
Before putting it into operation, allow sufficient time for the device to acclimatise
to the operating environment:
Temperature difference (°C) (operating
surroundings/outside)
A26361-K1182-Z120-1-7619, edition 3
5
10
15
20
25
30
Acclimatisation time (hours) (minimum
values)
10
Getting started
"Technical data", Page
3
5
7
8
9
9