Transfer The Firmware File From The Flash Drive To The Touch Panel - AMX MXTD-1000 Instruction Manual

Upgrading Firmware
Directory Names for Firmware Files - by Touch Panel Type
Directory Name
"MXT-1000"
"MXD-1000"
"MXT-700"
"MXD-700"
"MXD-430"
3.
Copy the firmware (.kit) file to be transferred (for example, "SW5968_ModeroX_v2_103_52.kit") into this directory
on the flash drive.
Make sure this is the only .kit file in this directory - if not, the latest version will be
used.
4.
Eject or unmount the flash drive from the PC.

Transfer the Firmware File From the Flash Drive to the Touch Panel

1.
Connect the USB Flash Drive to one of the USB Type A ports on the panel.
The Micro USB port cannot be used for firmware upgrades.
2.
Go to the Install Firmware setup page (Configuration->Admin->Install Firmware):
a.
Press and hold the Sleep button for 3 seconds to open the Settings page.
FIG. 51 Settings page
b.
From the Settings page, select the Configuration page. This may require entering a password.
c.
From the Configuration page, select Admin.
d.
From the Admin Configuration page, select Install Firmware.
3.
In the Firmware Installation page, select New to install new firmware from external disk.
4.
The popup page displays the name of the firmware file (for example, "SW5968_ModeroX_v2_103_52.kit").
5.
Select Yes, and follow the directions displayed on the popup.
6.
Once the panel reboots, it will perform the firmware upgrade.
After the upgrade, the device contains the newly loaded version of firmware.
54
Panel Type(s)
MXT-1000 (FG5968-03)
MXD-1000-P (FG5968-07)
MXD-1000-L (FG5968-13)
MXT-700 (FG5968-04)
MXD-700-P (FG5968-08)
MXD-700-L (FG5968-14)
MXD-430-P (FG5968-15)
MXD/T-1000, MXD/T-700 and MXD-430 Modero X Series® Touch Panels
MXT-1000-NC (FG5968-24)
MXD-1000-P-NC (FG5968-25)
MXD-1000-L-NC (FG5968-26)
MXT-700-NC (FG5968-27)
MXD-700-P-NC (FG5968-28)
MXD-700-L-NC (FG5968-29)