Honda TRX350TM Rancher Service Manual page 174

CRANKCASE/TRANSMISSION/CRANKSHAFT
MAINSHAFT
IDLE GEAR SHAFT
M2 GEAR (15T)
MAINSHAFT
Always install the thrust washer and snap ring
with the chamfered (rolled) edge facing away
from the thrust load.
Install the snap ring so that its end gap aligns
with the groove in the splines.
Make sure that the snap ring is fully seated in the
shaft groove after installing it.
Align the lock washer tabs with the spline washer
grooves.
11-8
REVERSE IDLE GEAR (13/23T)
M1 GEAR (11T)
M4 GEAR (29T)
M4 BUSHING
WASHER
WASHER
M3 GEAR (21T)
SNAP RING
SPLINE WASHER
Washer and snap ring direction:
G G
A A l l i i g g n n
L L O O C C
WASHER
M5 GEAR (25T)
M5 BUSHING
A A P P
S S N N A A P P R R I I N N G G
S S P P L L I I N N E E
W W A A S S H H E E R R
K K W W A A S S H H E E R R