Switches; Ignition Switch Removal - Suzuki VL125 Service Manual

ELECTRICAL SYSTEM 6-27
TURN SIGNAL/SIDE-STAND RELAY
The turn signal/side-stand relay 1 is composed of the turn sig-
nal relay, side-stand relay and diode.
• Remove the luggage box. (!6-7)
INSPECTION
Before removing the turn signal/side-stand relay, check the op-
eration of the turn signal light.
If the turn signal light does not illuminate, inspect the bulb, turn
signal switch and circuit connection.
If the bulb, turn signal switch and circuit connection are OK, the
turn signal relay may be faulty; therefore, replace the turn sig-
nal/side-stand relay with a new one.
NOTE:
* Make sure that the battery is fully charged.
* Refer to the page 6-16 for the side-stand relay and diode in-
spection.

SWITCHES

IGNITION SWITCH REMOVAL

• Remove the left frame cover. (!5-3)
• Disconnect the coupler.
• Remmove the ignition switch by removing the bolt.
/ Ignition switch bolt: 10 N . m (1.0 kgf . m)