Suzuki VL125 Service Manual page 49

3-14 ENGINE
PISTON
• Place a clean rag over the cylinder base to prevent piston pin
circlips from dropping into the crankcase. Remove the piston
pin circlips with long-nose pliers.
• Drive out the piston pins by using proper drift.
NOTE:
Scribe the cylinder position on the head of the respective pis-
tons.
GENERATOR COVER
• Remove the generator cover.
• Remove the starter idle gear 1 and shaft 2.
• Remove the oil sump filter 3.
GENERATOR ROTOR
NOTE:
When removing the primary drive gear nut ( 9 3-17), do not
remove the generator rotor. The generator rotor is used when
removing the primary drive gear nut.
• With the rotor held immovable using the special tool, loosen
the rotor bolt.
% 09930-44530: Rotor holder
• Remove the rotor by using the special tool.
% 09930-32610: Rotor remover