Suzuki VL125 Service Manual page 80

REASSEMBLY
Assemble the countershaft and driveshaft in the reverse order
of disassembly. Pay attention to following points:
NOTE:
Always use new circlips.
NOTE:
Before installing the gears, coat lightly engine oil to the driveshaft
and countershaft.
7
* Never reuse a circlip. After a circlip has been removed
from a shaft, it should be discarded and a new circlip
must be installed.
* When installing a new circlip, care must be taken not
to expand the end gap larger than required to slip
the circlip over the shaft.
* After installing a circlip, always ensure that it is com-
pletely seated in its groove and securely fitted.
• When installing a new circlip, pay attention to the direction of
the circlip. Fit it to the side where the thrust is as shown in
figure.
TRANSMISSION GEARS AND RELATED PARTS
ENGINE 3-45