Table of Contents
Advertisement
3.6.13 Onboard LAN2 Control
Options are "Enabled" and "Disabled". Select Disabled if you don't want
to use the onboard LAN controller2.
Note: Correct sequence of onboard Lan controllers(Lan1 & Lan2) shows
in the "Onboard Device" BIOS view.
Note:
DRAM default timings have been carefully cho-
sen and should ONLY be changed if data is
being lost. Please first contact technical sup-
port.
3.6.14 Onboard FDC Controller
When enabled, this field allows you to connect your floppy disk drives to
the onboard floppy disk drive connector instead of a separate controller
card. If you want to use a different controller card to connect the floppy
disk drives, set this field to Disabled.
3.6.15 Onboard Serial Port 1
The settings are "3F8/IRQ4", "2F8/IRQ3", "3E8/IRQ4", "2E8/IRQ3",
and "Disabled" for the on-board serial connector.
3.6.16 Onboard Serial Port 2
The settings are "3F8/IRQ4", "2F8/IRQ3", "3E8/IRQ4", "2E8/IRQ3",
and "Disabled" for the on-board serial connector.
Figure 3.9: Super I/O Device
53
Chapter 3
Advertisement
Table of Contents
