Rear Brake Pedal; Drive Chain; Front Suspension - Suzuki GSX1400K2 Setup Manual

REAR BRAKE PEDAL
Check the rear brake pedal height.
If
the rear brake
pedal height is nol correct, adjust in the following
manner:
Brake pedal height: 35-45
mm
(1.4-1.8 in)
1. Loosen the lock nut
®.
2.
Rotate the push rod @ to locate the pedal at
35­
45 mm (1.4-1.8 in) below the top face of the foot ­
rest
©.
Be sure to measure this height carefully.
3. Tighten the lock nut
®
to the specified torque.
C!J
Rear brake push rod lock n,ut @:
18 N·m (1.8 kgf-m)
DRIVE CHAIN
Check the drive chain slack. If it is too tight or too
loose, follow these procedures.
Loosen the axle nut. Loosen the lock nut. Adjust the
slack in the drive chain by turning the right and left
chain adjuster bolts. Proper chain slack is obtained
when there is 20-30 mm (0.8-1.2 in) up and down
slack in the chain, at a point midway between the two
sprockets.
Drive chain slack: 20-30 mm (0'.8--1 2 in)
A Axle nut C: Adjuster bolt
8: Lock
nut
0: Reference marks
After adjusting, tighten the axle nut to the specified
torque. Tighten the lock nuts securely.
t:!]
Rear axle nut: 100 N·m (10.0 kgf-m)
ICAUTIONI
!Make sure that the rear sprocket is properly
aligned with the engine sprocket. Verify the
reference marks on the swing-arm
by
sighting
down along the chain from the rear end of the
motorcycle.
FRONT SUSPENSION
Checking spring setting
Make sure of the spring setting of the front suspen ­
sion. The standard setting for this motorcycle is as
indicated in the table below.
[ Standard setting Position 5
]
,BEmIImJ
Check that riglht and left spr1ing settings are rin
the same position.
Please refer to the owner's manual for correct adjust ­
ment.
A: Adjuster
33