Panasonic KX-TDA50 Installation Manual page 56

2.2.9 Wall Mounting (KX-TDA50)
3.
Hook the main unit on the screw heads.
Mounting on Concrete or Mortar Wall
WARNING
•
Make sure that the wall that the cabinet will be attached to is strong enough to support the
cabinet. If not, it is necessary for the wall to be reinforced.
•
Only use the wall-mounting equipment (screws, washers) included with the PBX.
•
Be careful not to drop any components. Dropping components may damage them or cause an
injury.
CAUTION
•
Do not block the openings of the cabinet. Allow space of at least 20 cm (8 in) above and 10 cm (4 in)
at the sides of the cabinet.
•
Make sure that the surface behind the cabinet is flat and free of obstacles, so that the openings on the
back of the cabinet will not be blocked.
•
When driving the screws into the wall, be careful to avoid touching any metal laths, wire laths or metal
plates in the wall.
•
When this product is no longer in use, make sure to detach it from the wall.
Note
•
For details about the dimensions and weight of the PBX, refer to "1.3.1 General Description".
1.
Place the reference for wall mounting (on the last page of this manual) on the wall to mark the three screw
positions.
130 mm (5-1/8 in)
56 Installation Manual
250 mm
(9-13/16 in)
Document Version 2010-11