Initial Start-Up - Master Spas jet Away Owner's Manual

Master Spa Parts Call Us Today : (920) 727 - 1700
DOWN EAST AND FREEDOM - SINGLE PUMP SYSTEM

Initial Start-up

When your spa is first energized, it will go into Priming mode, indicated by Pr.
The Priming mode will last for less than 5 minutes and then the spa will begin to
heat the spa and maintain the water temperature in the Standard mode.
Temp Set (80˚F - 104˚F / 26.0˚C - 40.0˚C)
The factory preset temperature is set at 100˚F/ 37.5˚C. The last measured
temperature is constantly displayed on the LCD.
Note that the last measured spa temperature displayed is current only
when the pump has been running for at least 2 minutes.
Press the "Temp" button to display the temperature previously set. This set
temperature is flashed on the display. Pressing the "Temp" button a second time,
while it is still flashing, will cause the set temperature to increase or decrease
depending on which direction was last chosen. Each press to follow will change
the set temperature in the same direction. If the opposite direction is desired,
release the pad and let the display revert to the actual water temperature. Press
the button to display the set temperature and again to make the temperature
change in the desired direction.
Jets
Touch the "Jets" button once to activate the low speed of the pump and again
for the high speed. Press the "Jets" button again to turn off the pump. If left
running, the pump's low speed will automatically turn off after 4 hours, and the
pump's high speed will automatically turn off after 15 minutes. The low speed
pump may also activate for at least 2 minutes every 30 minutes to detect the spa
temperature and then to heat, to the set temperature if needed, depending upon
mode. When the low speed turns on automatically, it cannot be deactivated from
the panel; however the high speed may be started.
55 M A S T E R S P A S
America's Leader In Luxury
Master Spa Parts - 1068 American Drive, Neenah, WI, 54956, USA