Master Spas - Legend Series - Lsi 557; Initial Start-Up - Master Spas jet Away Owner's Manual

Master Spa Parts Call Us Today : (920) 727 - 1700
MASTER SPA - LEGEND SERIES - LSI 557

Initial Start-up

When your spa is first actuated, it will go into Priming mode (after displaying
some configuration information). The Priming mode will last for up to 4
minutes and then the spa will begin to heat and maintain the water temperature
in the Standard mode. You can exit Priming mode early by pressing "Temp."
Temp Set (80˚F - 104˚F / 26.0˚C - 40.0˚C)
The start-up temperature is set all 100˚F/37.5˚C.The last measured temperature
is constantly displayed on the LCD.
Note that the last measured spa temperature displayed is current only
when the pump has been running for at least 2 minutes.
Temp
Press "Temp" button once to display the set temperature.To change the set tem-
perature, press the pad a second time before the LCD stops flashing. Each press of
the "Temp" button will continue to either raise or lower the set temperature.
If the opposite direction is desired, release the pad and let the diesplay revert to
the current water temperature. Press the pad to display the set temperature, and
again to make the temperature change in the desired direction.
After three seconds, the LCD will automatically display the last measured spa
temperature.
Mode
A button combination is used to switch between standard, economy, and sleep
modes. Press "Temp" followed by "Light" to enter mode programming, press
"Temp" to cycle through to desired mode (LCD flashes until confirmed), then
press "Light" to confirm selection.
40 M A S T E R S P A S
America's Leader In Luxury
Master Spa Parts - 1068 American Drive, Neenah, WI, 54956, USA