Initial Start-Up - Master Spas jet Away Owner's Manual

Master Spa Parts
MASTER SPA - LEGEND SERIES

Initial Start-up

When your spa is first actuated, it will go into Priming mode (after displaying
some configuration information). The Priming mode will last for up to 4 minutes
and then the spa will begin to heat and maintain the water temperature in the
Standard mode. You can exit Priming mode early by pressing "Warm" or "cool".
Icon Legend
Temp Set (80˚F - 104˚F / 26.0˚C - 40.0˚C)
The factory preset temperature is set at 100˚F/ 37.5˚C. The last measured
temperature is constantly displayed on the LCD.
Note that the last measured spa temperature displayed is current only
when the pump has been running for at least 2 minutes.
Warm / Cool
Press the "Warm" or "Cool" button once to display the set temperature. Each
time either button is pressed again, the set temperature will increase or decrease
depending on which button is pressed. After three seconds, the LCD will
automatically display the last measured spa temperature.
Time
When time hasn't been programmed, the TIME icon flashes. To set the time,
press "Time" then "Mode/Prog". Use the "Warm" and "Cool" buttons to adjust
the time.
America's Leader In Luxury
Master Spa Parts - 1068 American Drive, Neenah, WI, 54956, USA
Heat Icon - Indicates different stages of heating.
Light Icon - Indicates light is on; On spas with a rotating LED
light system, the light icon will rotate if the color wheel is
changing.
Jets Icon - Spins fast on high speed; spins slow on low speed.
32
Call Us Today : (920) 727 - 1700
M A S T E R S P A S