Initial Start-Up - Master Spas jet Away Owner's Manual

Master Spa Parts Call Us Today : (920) 727 - 1700
DOWN EAST (2 -3 PUMP SYSTEMS)
East Hampton / Portsmouth / Windsor / Exeter / Cape Cod
(2 Pump System)
East Hampton SE / Portsmouth SE / Windsor SE / Exeter SE/
Cape Cod SE (3 Pump System)

Initial Start-up

When your spa is first activated, it will go into priming mode (after displaying
some configuration information). The Priming mode will last for up to 4 minutes
and then the spa will begin to heat the spa and maintain the water temperature in
the Standard mode. You can exit Priming mode early by pressing "Cool".
Temp Set (80˚F - 104˚F / 26.0˚C - 40.0˚C)
The preset temperature is set to 100˚F / 37.5˚C. The last measured
temperature is constantly displayed on the LCD.
Note that the last measured spa temperature displayed is current only
when the pump has been running for at least 2 minutes.
Cool / Warm
Press the "Cool" or "Warm" button once to display the set temperature.
Each time either button is pressed again, the set temperature will increase or
decrease depending on which button is pressed. After three seconds, the LCD
will automatically display the last measured spa temperature.
47
M A S T E R S P A S
America's Leader In Luxury
Master Spa Parts - 1068 American Drive, Neenah, WI, 54956, USA