Installation Instructions - Master Spas jet Away Owner's Manual

Master Spa Parts

INSTALLATION INSTRUCTIONS

1.) Put spa in final position that allows for access to equipment of spa
2.) Remove front side panel (This is the side where the main topside control
4.) Be sure all pump and heater unions are secure. Each pump has 2 unions and
5.) Fill spa to the "minimum safe water level" sticker.We recommend filling the
6.) Turn the power on to the spa. Spa will go through its priming mode.
7.) Be sure the jets in your spa are opened.
America's Leader In Luxury
Master Spa Parts - 1068 American Drive, Neenah, WI, 54956, USA
components.
panel is located) so electrical can be hooked up to the spa system pack.
Panels are removed by unscrewing the screws in the corner sections and
then lifting up the panels out of the retaining tracks.
the heater has 2 unions. A newly delivered spa may have loose unions caused
in transporting the spa. Check that all slice valves are open, in the up
position. Again, the slice valves may become closed during transportation
of the spa.
Slice Valve
and Pump Union
Be sure outside drain fitting is fully closed.
spa through the filter area.
This lasts approximately 5 minutes.
On all Master Spas / Down East: The jets open by turning the jet
collar clockwise.
On all Freedom Spas: The jets open by turning the jet collar counter
clockwise.The smaller jets in the Freedom line cannot be opened
or closed.
Note:The Master Blasters are only turned on/off through the use of the
"Jets 3" button or the divertor valve.
Call Us Today : (920) 727 - 1700
Removing of Panels
16
M A S T E R S P A S