Regular Maintenance Procedures - Master Spas jet Away Owner's Manual

Master Spa Parts

REGULAR MAINTENANCE PROCEDURES

Note:
These are areas that will require the spa owner to perform routine
maintenance.These are not areas covered under the warranty
of the spa.
CLEANING JETS
TO CLEAN JETS
CLEANING DIVERTER VALVES
America's Leader In Luxury
Master Spa Parts - 1068 American Drive, Neenah, WI, 54956, USA
The majority of jets in your spa can individually be turned on/off. If any of
these jets become hard to turn, it will be necessary to remove the jet to clean
it as grit/sand and mineral deposit may be present.
Jets in the Master Spa and Down East line are removed by turning the grey
collar counter clockwise and then pulling out the jet. Most jets in the
Freedom Spa can be removed by turning the collar clockwise, then pulling
the jet out.The smallest jets in the Freedom line are fixed and cannot be
removed.
Most jets in the Down East and Freedom Spas can be removed by turning the
collar clockwise, then pulling the jet out.The smallest jets in the Down East
line are removed by turning the collar counter clockwise and then pulling the
jet out.The smallest jets in the Freedom Spa line are fixed and cannot be removed.
Place the jet(s) in a bucket, fully immerse in white vinegar. Let the jet(s) soak
overnight and then rinse with water. Reinstall the jet(s). It may also be
necessary to clean the grit/deposit from the white jet body using an old
toothbrush.
Some Master Spas and Down East Spas have diverter valves. Due to mineral
deposits and grit/sand that may get into the internal parts of the diverter
valve, it may become hard to turn or freeze up totally. In this case, it is
necessary to remove the handle and cap of the diverter valve. Before
proceeding, make sure the power to the spa is turned off. (cont. next page)
Call Us Today : (920) 727 - 1700
71
M A S T E R S P A S