Table of Contents
Advertisement
5.2.3 Signal Name Display
SD Video line
: 480i, 575i
HD Video line : 7 2 0 P / 5 0 , 7 2 0 P / 6 0 , 1 0 8 0 i / 5 0 , 1 0 8 0 i / 6 0 , 1 0 8 0 P / 5 0 , 1 0 8 0 P / 6 0
(59.94 Hz is expressed as 60 Hz.)
PC line
: VGA, SVGA, XGA, SXGA, WUXGA, 480i, 575i, 720P/50, 720P/60,
1080i/50, 1080i/60, 1080P/50, 1080P/60
DVI line
: VGA, SVGA, XGA, SXGA, WUXGA, 480i, 575i, 720P/50, 720P/60,
1080i/50, 1080i/60, 1080P/50, 1080P/60
With no signal
being input
: No Sync
5.3 Settings and Key Operation
The setting function is for signals currently being inputted and selected.
By pressing the Menu once, the Adjustment screen can be displayed.
5.3.1 Direct Brightness/Contrast/User Memory Settings and Adjustments
1) Contrast
Press the "CONT/BRT/EXIT" key, and the settings show up. The settings are adjusted
with the "+" or "-" key. Press the "CONT/BRT/EXIT" key again to save the current settings
and to exit this mode.
2) Brightness
Press the "CONT/BRT/EXIT" key, and the settings show up. The settings are adjusted
with the "INPUT1" or "INPUT2" key. Press the "CONT/BRT/EXIT" key again to save the
current settings and to exit this mode.
3) User Memory
By pressing the "CONT/BRT/EXIT" key, the setting values can be displayed, allowing
settings to be made by using the "MENU" key. Eight types of settings from Setting 1 to
Setting 8 are possible. When the "CONT/BRT/EXIT" key again, the setting value is
registered, and the setting procedure is terminated.
5.3.2 Input Signal Selection
At the first key operation, the current input signal is accepted. By using the key within 5
seconds, the input signal is switched over. The INPUT1 and INPUT2 keys are used to
select input signal . The last input signal is picked up in its shut-off state when the power
is turned on again.
For setting of input signals, use the "Memory Select Screen" screen as described under
5.9.
5.3.3 OSD Menu Operation
Press the MENU key, and the Status screen shown below appears. The tabs are selected
with the "+" or "-" key and fixed with the"MENU"key. The selected tabs change color. All
the new settings are saved by pressing the EXIT key once. Press the EXIT key again, and
the operation is completed. If no saving takes place, select UNDO, press MENU first and
then EXIT. The operation ends with the previous settings intact.
9
5. Operation
Advertisement
Table of Contents
