Settings And Key Operation - Ikegami MLW-2625C Instruction Manual

5.3 Settings and Key Operation

The setting function is for signals currently being inputted and selected.
Press the MENU key once, and the main-screen adjustments can be made. At the second
push, the sub-screen adjustments can be made.
5.3.1 Direct Brightness/Contrast Settings and Adjustments
1) Contrast
Press the "CONT/BRT" key, and the settings show up. The settings are adjusted with the
"+" or "-" key. Press the "CONT/BRT" key again to save the current settings and to exit
this mode.
2) Brightness
Press the "CONT/BRT" key, and the settings show up. The settings are adjusted with the
"INPUT1" or "INPUT2" key. Press the "CONT/BRT" key again to save the current settings
and to exit this mode.
5.3.2 Input Signal Selection
At the first key operation, the current input signal is accepted. By using the key within 5
seconds, the input signal is switched over. The INPUT1 and INPUT2 keys are used to
select the main screen and sub screen, respectively. The last input signal is picked up in
its shut-off state when the power is turned on again.
INPUT1: Used to select the main-screen input, INPUT2: Used to select the sub-screen
input.
The input being selected with INPUT1 cannot be selected with INPUT2. The Video and
S-Video signals, PC and COMP signals, as well as OP-PC and OP-DVI signals cannot all
be selected in pairs.
5.3.3 P.SEL
The double-screen display selector key is pressed to change the display in the order of
PINP1, PINP2, SBS1 and SBS2.
Sub
Main
PINP1
Small sub-screen
display
5.3.4 SWAP
In the double-screen display mode, this key is used to switch between the main and sub
screens.
5.3.5 OSD Menu Operation
Press the MENU key, and the Status screen shown below appears. The tabs are selected
with the "+" or "-" key and fixed with the"MENU"key. The selected tabs change color. All
the new settings are saved by pressing the EXIT key once. Press the EXIT key again, and
the operation is completed. If no saving takes place, select UNDO, press MENU first and
then EXIT. The operation ends with the previous settings intact.
Sub
Main
PINP2
Large sub-screen Reduced full display
display
9
Sub Main Sub
SBS1
Dot-by-dot display
5. Operation
Main
SBS2