Sherwood Newcastle P-965 Operating Instructions Manual page 52

When selecting the TONE CONTROL
Press the CURSOR UP( )/DOWN( ) buttons to select the TONE CONTROL, then press the ENTER
1
button.
POWER ON
STANDBY
MAIN
CH.
SET
VOL CH/
ADJUST
MUTE
DECODE
DSP DSP
RETURN
STEREO
1 3
2
4 6
5
7 9
8
OSD/MENU
DISP 0 ENT
MI M2 M3
RNC-510
Note:
• When the pure audio function is activated, the TONE CONTROL cannot be selected.
Press the CURSOR UP( )/DOWN( ) buttons to select the desired item.
2
STANDBY POWER ON
MAIN
CH.
SET
VOL CH/
ADJUST
MUTE
DECODE
DSP DSP
RETURN
STEREO
1 3
2
4 6
5
7
9
8
OSD/MENU
0
DISP ENT
MI M2 M3
Press the CURSOR LEFT( )/RIGHT( ) buttons to select the desired mode.
3
STANDBY POWER ON
MAIN
CH.
SET
VOL CH/
ADJUST
MUTE
DECODE
DSP DSP
RETURN
STEREO
1 3
2
4 6
5
7 9
8
OSD/MENU
0
DISP ENT
MI M2 M3
RNC-510
When CINEMA EQ mode is selected
• When 96kHz PCM(2 channel stereo) signals are
input, the cinema EQ function cannot be activated.
On : Select this to compensate for edgy or shrill movie
sound tracks.
Off : Select this to cancel the cinema EQ function.
When TONE DEFEAT mode is selected
On : Select this when listening to a program source
without the tone effect.
Off : Select this when adjusting tone for your taste.
Note :
• When the tone defeat mode is set to On, the tone (bass
and treble) cannot be adjusted.
T ON E C O N T R O L
C I N EMA E Q
T O N E D E F E A T
R E T U R N : B a c k
• Each time these buttons are pressed, " " and " "
are moved to the corresponding mode.
• Each time these buttons are pressed, the modes change
as follows:
When the tone defeat mode is set to Off to adjust
the tone (bass and treble)
1. Press the CURSOR UP( )/DOWN( ) buttons to
select the desired tone mode.
• Each time these buttons are pressed, " " is moved to
the tone defeat mode or the corresponding tone mode.
2. At the desired tone mode, press the CURSOR
LEFT( )/RIGHT( ) buttons to adjust the selected
tone as desired.
• The tone level can be adjusted within the range of -10
~+10 dB.
• In general, we recommend the bass and treble to be
adjusted to 0 dB(flat level).
• Extreme settings at high volume may damage your
speakers.
3. To complete tone adjustment, repeat the above steps 1
and 2.
52
:
Off
:
Off
, : S e l e c t