Sherwood Newcastle P-965 Operating Instructions Manual page 10

7. CONNECTING SYSTEM CONTROL
• Connect this jack to the DIGI LINK jack of the external
Sherwood component that uses the DIGI LINK II or III
remote control system.
8. CONNECTING DC TRIGGER OUTs
• Connect components that need to be triggered by DC
under certain conditions as follows :
• Connect a component to DC TRIGGER OUT 1 jack that
allows DC 12 V to turns on or off when this unit's power is
turned on or off.
In case that this unit is connected to Sherwood power
amplifier A-965, connect DC TRIGGER IN jack of A-965
to DC TRIGGER OUT 1 jack for system power control.
• Connect a component to DC TRIGGER OUT 2 jack that
allows DC 12 V to turn on or off when a specific input
source is selected or not.
• For details, refer to the operating instructions of the
components to be connected .
• To link DC TRIGGER OUT 2 with a specific input source, refer to "When selecting the DC TRIGGER 2 SETUP" on page 55.
Notes :
• This output voltage (12 V d.c., 100mA ) is for (status) control only , it is not sufficient for drive capability.
• When making DC TRIGGER connection, you should use the stereo mini cord, not a mono mini cord.
ROOM 2 connections
• ROOM 2 playback feature allows you to play a different program source in another room as well as one source in the main
room at the same time.
• For ROOM 2 playback, connect the VIDEO 2 / ROOM 2 OUT jacks and the COAXIAL DIGITAL OUT to the amplifier, TV. etc.
installed in another room.
Note :
• To minimize hum or noise, use high quality connection cords.
Main room
This unit
OUT
VIDEO2/
ROOM2
OUT
10
DIGI-LINK
1 2
DC TRIGGER OUT
12V d.c. 100 mm A
Another room(Room 2)
IN IN
S-VIDEO VIDEO
TV or projector
L
AUDIO
IN
R
COAXIAL
DIGITAL IN
Amplifier
Sherwood component
with DIGI LINK II or III
CD player
System
control
Tape deck
cord
DVD player
Component such as
Sherwood A-965 to be
triggered by DC when this
unit's power is turned on
Component to be triggered
by DC when a specific input
source is selected
Speakers