Entering A Setup Code - Sherwood Newcastle P-965 Operating Instructions Manual

ENTERING A SETUP CODE

• This remote control can control up to ten different components.
• Before operating audio and video components using the remote control supplied with this unit, the setup code for each
component should be entered.
• For system remote control operation between Sherwood components, "001" was stored previously in the memory of each
device such as "AUD 1" and "AUD 2" for this unit, "CD" for CD player, "TAPE" for tape deck , "TV" for TV and "DVD" for DVD
player.
So, you don't need to enter its code for each Sherwood component except in such a case that its code does not work.(When
entering each setup code for Sherwood CD player and tape deck , do from the below step
Turn on the component you want to control.
1
Example) When entering the setup code for this unit,
turn on this unit.
Note:
If your component has the discrete POWER ON and OFF
buttons, please do not turn on the component manually.
Press both the MAIN and OSD/MENU
3
(/ENTER) buttons simultaneously for 3
seconds.
POWER ON
STANDBY
MAIN
CH.
SET
VOL CH/
ADJUST
MUTE
DECODE
DSP DSP
RETURN
STEREO
1 3
2
4 6
5
7 9
8
OSD/MENU
DISP 0 ENT
MI M2 M3
RNC-510
Then the setup menu will be displayed on the LCD
screen.
Note:
If the display of the corresponding mode disappears,
start again from the above step
Select the device corresponding to the
5
component you want to control.
Example) When selecting the "AUD 1" for
unit or amplifier, etc.
STANDBY
P-PRO
AUD1
CD
DVD
TAPE
AUX
SELECT
MAIN
OSD/MENU
ENT
or the current mode.
POWER ON
AUD2
TV
VCR
SAT
CABLE
Find the setup code for your component
2
referring to "Set-Up Code Table" in the
operating manual of this remote control.
Example) The 3 digit setup codes for the Sherwood
"Audio" are 001,024, ...(Hint:The correct
setup code for this unit is "001".)
Select the Pre-PROgramming mode.
4
STANDBY
Then the Pre-PROgramming menu will be displayed.
Select the device from which the appropriate
6
3 digit setup code table will be selected.
Example) If it is the "AUD 1" code table,
select the "AUD 1" .
STANDBY
AUD1
AUD1 AUD2
CD TV
DVD VCR
TAPE SAT
AUX CABLE
TABLE
19
.)
POWER ON
SETUP
P-PRO LEARN
FAV MACRO
PUNCH RECAL
ERASE EDIT
LIGHT CLONE
POWER ON
AUD1
001 SAVE
EXIT
DOWN UP
ENTER