Sherwood Newcastle P-965 Operating Instructions Manual page 20

Enter the 3 digit setup code aiming the
7
remote control at the REMOTE SENSOR on
the component.
STANDBY POWER ON
AUD 1
001 SAVE
EXIT
DOWN UP
ENTER
MAIN
CH.
SET
CH/
VOL
ADJUST
MUTE
DECODE
DSP DSP
For "001" :
RETURN
STEREO
1 3
2
4 6
5
7 9
8
OSD/MENU
For "102" :
DISP 0 ENT
MI M2 M3
RNC-510
Your component will be turned off when the right
code is entered.
Continue to enter the corresponding codes until your
component turns off.
To resume the MAIN menu mode, press the
9
MAIN button twice briefly.
STANDBY POWER ON
MAIN
MAIN
CH.
SET
CH/
VOL
ADJUST
MUTE
DECODE
DSP DSP
RETURN
STEREO
1 3
2
4
6
5
7 9
8
OSD/MENU
DISP 0 ENT
MI M2 M3
RNC-510
Each time the MAIN button is pressed, the previous
mode is resumed.
Repeat the above steps
11
0 0 1
1 0 2
The selected device
to for each of your other components.
20
Confirm that it is the right code by selecting
8
the SAVE.
STANDBY
AUD 1
001 SAVE
EXIT
DOWN UP
ENTER
The code is saved and the Pre-PROgramming mode
is resumed.
When you do not want to save the code, select the
EXIT on the LCD screen or press the MAIN button.
Operate the component using the
10
corresponding function buttons.
If any of the buttons fails to operate as they should,
start from the step again to enter the next setup code.
Notes:
If the Manufacturer/Brand for your component is not
listed in "Set-Up Code Table" in the operating manual
of this remote control, please use the " 2 Auto Scan
Method" on page 13 in the operating manual of this
remote control.
Although each setup code is designed to work with
many different modes, certain codes may not work
with some models.( Also, certain codes may only
operate some of the functions available on a given
model.)
POWER ON