Sherwood Newcastle P-965 Operating Instructions Manual page 31

Adjusting each channel level with test tone
• The volume level of each channel can be adjusted easily with the test tone function.
Note: When speakers are switched off , the test tone function does not work.
Enter the test tone mode.
1
STANDBY
AUD2
SLEEP
DIMM S.A/B
ROOM2 SUR.B
T.TON PURE
OSD PARA.
PAGE1
At each channel, adjust the level as desired
2
until the sound level of each speaker is
heard to be equally loud.
MULTI CONTROL
or
DOWN
UP
• You can select the desired channel and adjust its
level with repeating the steps
"Adjusting the current channel levels" procedure.
Adjusting the current channel levels
• After adjusting each channel level with test tone, adjust the channel levels either according to the program sources
or to suit your tastes.
• If you have performed the CH LEVEL SETUP procedure on the OSD menu, you can memorize the adjusted
channel levels into preset memory(PRESET 1, PRESET 2) and recall the memorized whenever you want.(Refer to
"SETTING THE CH LEVEL SETUP" on page 60.)
Select the desired channel.
1
CH.SEL
or
POWER ON
D/A
STANDBY POWER ON
MAIN
CH.
SET
CH/
CH/
VOL
ADJUST
MUTE
ADJUST
DECODE
DSP DSP
RETURN
STEREO
1 3
2
4 6
5
7 9
8
OSD/MENU
DISP 0 ENT
MI M2 M3
RNC-510
and in
STANDBY POWER ON
CH.
MAIN
SEL
CH.
SET
CH/
VOL
ADJUST
MUTE
DECODE
DSP DSP
RETURN
STEREO
1 3
2
4 6
5
7 9
8
OSD/MENU
DISP 0 ENT
MI M2 M3
RNC-510
31
• The test tone will be heard from the speaker of each
channel for 2 seconds as follows:
FL C FR
Front Left Center Front Right
SUB SL ( SC) or (
SUBwoofer Surround Left (Surround Center)
• Depending on the speaker setting(None or No), the
test tone of the corresponding channel is not
available.
• ( ): possible depending on whether the surround back
channel is set to 2 CH or 1 CH.
Cancel the test tone function.
3
STANDBY
AUD2
SLEEP D/A
DIMM S.A/B
ROOM2 SUR.B
T.TON PURE
OSD PARA.
PAGE1
• Each time this button is pressed, the corresponding
channel is selected as follows:
FRONT-L FRONT-C FRONT-R
SUBWOOFER SURR-L ( SURR-C) or ( BACK-L BACK-R)
• Depending on the speaker setting and surround
mode, etc., some channels cannot be selected.
• ( ): possible depending on whether the surround back
channel is set to 2 CH or 1 CH.
Note: When speakers are switched off, only
FRONT-L and FRONT-R channels can be
selected.
SR
Surround Right
B L BR)
(Surr. Back Left Surr. Back Right)
POWER ON
SURR-R