Sherwood Newcastle P-965 Operating Instructions Manual page 42

Entering a label
• This function can be operated on the input sources
except TUNER and TAPE MONITOR.
Select the desired input source to enter its
1
label.
INPUT SELECTOR
VIDEO AUDIO 8CH DIRECT
or
• You can select "VID 6" or "7.1 IN" on the page 2
of "AUD 1" on the remote control.
Select the character on the flickering digit.
3
MULTI CONTROL
• Each time the MULTI CONTROL knob is rotated,
the characters change as follows:
Blank ( )
Alphabets: A~Z, a~z
Numerals: 0~9
Symbols:
Correcting or clearing a label
Select the desired input source to be
1
rectified or cleared.
INPUT SELECTOR
VIDEO AUDIO 8CH DIRECT
or
• You can select "VID 6" or "7.1 IN" on the page 2 of
"AUD 1" on the remote control.
POWER ON
STANDBY
AUD1
TUNER VID1
CD VID2
T.MON VID3
AUX VID4
PHONO VID5
PAGE1
POWER ON
STANDBY
AUD1
TUNER VID1
CD VID2
T.MON VID3
AUX VID4
PHONO VID5
PAGE1
42
Press the LABEL button to enter the label
2
input mode.
Example ) When selecting VIDEO 1.
LABEL
Confirm your selection.
4
LABEL
• Then the next digit will flicker.
Repeat the above steps
5
the desired characters on the rest of the
digits.
• On up to 9 digits, the desired characters can be entered.
Note: If any of INPUT SELECTOR buttons is
pressed while entering a label, the label input
mode will be canceled.
Memorize the desired label.
6
ENTER/MEMO
Repeat the steps
2
label" procedure.
• To clear a label, make a blank on each digit and
memorize it, then the label is cleared and its factory
input source will be displayed.
• If the LABEL button is pressed for more than 3
seconds, blanks will be made on all the digits at
once.
and to enter
~ in "Entering a