Sherwood Newcastle P-965 Operating Instructions Manual page 32

Adjust the level of the selected channel as
2
desired.
MULTI CONTROL
or
DOWN
UP
Adjusting the Dolby Pro Logic IIx / Dolby Pro Logic II Music parameters
• When selecting either the Dolby Pro Logic IIx Music mode or the Dolby Pro Logic II Music mode depending on
whether "S/B CH" is set to "None" or not, you can adjust the various surround parameters for optimum surround
effect.(Refer to "When selecting the SPEAKER CONFIGURATION" on page 46.)
Press the DOLBY PL II MUSIC PARAMETER button to select the desired parameter.
1
STANDBY
PLII MUSIC
PARAMETER
or
At the desired parameter, adjust it as desired.
2
MULTI CONTROL
or
• If the parameter display disappears, start from the
step again.
STANDBY POWER ON
MAIN
CH.
SET
CH/
VOL CH/
ADJUST
MUTE
ADJUST
DECODE
DSP DSP
RETURN
STEREO
1 3
2
4 6
5
7 9
8
OSD/MENU
DISP 0 ENT
MI M2 M3
RNC-510
• Each time this button is pressed, the parameter changes and is
displayed for several seconds as follows;
Panorama mode("PANORAMA", default value : OFF)
This mode extends the front stereo image to include the
surround speakers for an exciting "wraparound" effect with
POWER ON
side wall imaging. Select "OFF" or "ON".
AUD2
SLEEP D/A
Center width control("C-WIDTH", default value : 0)
DIMM S.A/B
ROOM2 SUR.B
This adjusts the center image so it may be heard only from the
T.TON PURE
OSD PARA. center speaker, only from the left/right speakers as a phantom
PAGE1
image, or from all three front speakers to varying degrees.
The control can be set in 8 steps from 0 to 7.
Dimension control("DIMENSION", default value : 0)
This gradually adjusts the soundfield either towards the front
or towards the rear. The control can be set in 7 steps from -4
to +2.
STANDBY POWER ON
MAIN
CH.
SET
CH/
VOL CH/
ADJUST
MUTE
DECODE ADJUST
DSP DSP
RETURN
STEREO
1 3
2
4 6
5
7 9
8
OSD/MENU
DISP 0 ENT
MI M2 M3
RNC-510
32
Repeat the above steps
3
each channel level.
Repeat the above steps
3
adjust other parameters.
and to adjust
and to