Table of Contents
Advertisement
SE7500CW2 Server Board Technical Product Specification
7.1.3
BIOS Recovery Beep Codes
Beeps
1
One long beep – Video is active.
1-2
One long beep and two short beeps – The system is requesting the the user to
insert the BIOS recovery diskette.
7.1.4
POST Error Codes and Messages
The following table defines POST error codes and their associated messages. The BIOS
prompts the user to press a key in case of serious errors. The string "Error" to highlight the fact
that the system might be malfunctioning precedes some of the error messages.
During the POST, BIOS will show some human-readable information on the screen to get the
attention of the user when some errors have been run into. The table below list the possible error
number user may encounter and the related meaning. Most information here
show the HW device issue (failure or not found), some may include the initialization status.
If your system displays one of the messages marked below with an asterisk (*), write down the
message and contact Intel Customer Support. If your system fails after you make changes in the
Setup menus, reset the computer, enter Setup and install Setup defaults or correct the error.
0200 Failure Fixed Disk
Fixed disk is not working or not configured properly. Check to see if fixed disk is
attached properly. Run Setup. Find out if the fixed-disk type is correctly identified.
0210 Stuck key
Stuck key on keyboard.
0211 Keyboard error
Keyboard not working.
*
0212 Keyboard Controller Failed
Keyboard controller failed test. May require replacing keyboard controller.
0213 Keyboard locked - Unlock key switch
Unlock the system to proceed.
*
0230 Shadow Ram Failed at offset: nnnn
Shadow RAM failed at offset
*
0231 System RAM Failed at offset: nnnn
System RAM failed at offset
*
0232 Extended RAM Failed at address line: nnnn
Extended memory not working or not configured properly at offset
0250 System battery is dead - Replace and run SETUP
The CMOS clock battery indicator shows the battery is dead. Replace the battery and
run Setup to reconfigure the system.
0251 System CMOS checksum bad - Default configuration used
77
Revision 1.40
Table 38. BIOS Recovery Beep Codes
Reason
Table 39: Post Error Message
of the 64k block at which the error was detected.
nnnn
of in the 64k block at which the error was detected.
nnnn
Error Reporting and Handling
nnnn
Advertisement
Table of Contents
