Table of Contents
Advertisement
2.15.6
Working method F
Piped pockets, automatic feed of the piping strip, incision of piping ends, matching and
feeding of the flap
62
The working method F allows the matching of the flap as per pattern.
There is no need to sketch the flap manually.
The advantages are a simplified and quick handling as well as a
constantly high quality when processing chequered and striped fabrics.
Loading positions for right and left jacket front parts
–
Position the left jacket front part 10 at the rear light spot 7.
Position the right front part 1 at the front light spot 4.
It is advisable to generate a pocket program for left front parts (rear
light spot selected) and a pocket program for right front parts (front
light spot selected).
Thus, you only have to alter the pocket program on the main
screen when changing between left and right jacket front parts.
Caution: Danger of injury !
Do not reach into the working area of the positioning device when
triggering the individual steps of the positioning process.
Positioning and starting the sewing cycle
Example: Right jacket front part
With piping incision
1.
Position the piping strip 11 at the front stop 12.
(For the left jacket front part position the piping strip at the rear
stop 13). Position the piping strip also at the lateral stop.
2.
Step the right pedal back and hold it stepped down.
The right flap clamp 14 for the pocket bag 15 opens.
3.
Align the pocket bag 15 on the rest table 16 at the positioning
mark (e.g. thin adhesive tape).
4.
Release the right pedal.
The flap clamp 14 closes.
5.
Position the right jacket front part 1 with dart 2 on the light spot 4.
6.
Align the pocket incision at the light spot 5 (corner knife incision).
7.
If additionally equipped with vacuum:
Step forward on the left pedal.
The vacuum is switched on.
Advertisement
Table of Contents
