DURKOPP ADLER 745 - 34 - 2 Operating And Installation Instructions page 85

Positioning and starting the sewing cycle
Example: Right jacket front part
1. With automatic piping incision
Position the piping strip 2 at the front stop 8.
Position the piping strip also at the lateral stop 3.
2. Step forward on the right pedal and hold it stepped down.
The left piping clamp 4 opens.
3. Position the flap 5 at the lateral stop 6 and at the front stop 7.
4. Release the right pedal.
The left flap clamp closes.
5. Position the left pocket bag half 10 at the stop 9 above the flap 5.
6. Clamp pocket bag 10 and flap 5 together by stepping forward
on the right pedal. Hold the flap with one finger so that
it does not slip.
7. Release the right pedal. The left flap clamp 4 closes.
8. Step back on the right pedal and hold it stepped down.
The right flap clamp 12 opens.
9. Align the right pocket bag half 11 on the rest table
at the positioning mark (e.g. thin adhesive tape).
10. Release the right pedal. The right flap clamp 12 closes.
11. Position the right jacket front part with the dart at the light spot.
12. Align the pocket incision at the lengthwise line of the light spot
(center knife incision).
13. Step forward on the left pedal.
The transport carriage moves to the loading position.
The feeding clamps lower. The piping strip 2 is cut
and taken up by the pick-up folder.
14. Step forward on the left pedal.
The pick-up folder 13 lowers with the piping strip.
15. The left flap feed with the flap and the left pocket bag
half as well as the right flap feed with the right pocket bag
half swivel in.
16. Step forward on the left pedal. The flap clamps close.
The flap feeds open, lift and swivel out.
17. Step forward on the left pedal. The sewing cycle starts.
During the feeding process the pocket bag 10 is blown by air
for a better running into the folder.
1
85