Working Method A (Production Of Trousers) - DURKOPP ADLER 745-34-2 Operating Instructions Manual

2.15.1

Working method A (Production of trousers)

34
Possible processing variants
–
Front trousers pockets with underlaid pocket bag.
–
Hind trousers pockets with or without flap, with underlaid pocket
bag.
–
Hind trousers pockets with or without flap, with automatically fed
reinforcement strip.
Positioning method
Example: Hind trousers without flap, with underlaid pocket bag
st
1 step:
–
Select the pocket program at the control panel.
–
Push the pocket bag under pocket bag clamp 1 and position at the
markings 2.
As markings you can use e.g. adhesive tape attached to the fabric
sliding plate.
nd
2 step:
–
Position the hind trousers at the "Rear positioning point" 5 and the
marking 6.
–
Touch the left pedal.
The hind trousers is clamped in its position by the fabric
downholder 3 and the waistband clamp 4.
–
Smooth out the clamped hind trousers in the dart area.
–
If additionally equipped with vacuum:
Step the left pedal down as far as it will go and hold it stepped.
The vacuum is switched on.
rd
3 step:
–
Touch the left pedal.
The feeding clamps run to the front and lower onto the workpiece.
–
Position the piping strip 8 on the feeding clamps flush with the front
edges 9.
The alignment of the different types of piping on the feeding clamps
is described more precisely in the following.
See "Positioning the piping strip".
–
Touch the left pedal.
The folder 7 lowers.
–
Touch the left pedal once again.
The sewing cycle starts.