Table of Contents
Advertisement
2.15 Working methods
Working method
A
B
D
F
The individual working methods are described on the following pages.
The description is divided into the following items:
Loading positions
This item indicates which loading positions are used for the various
workpieces (e.g. left and right pieces).
Aligning the positioning aids
This section describes the setting and alignment of the positioning aids
(e.g. positioning marks, marking lamps, stops etc.).
Positioning and starting the sewing cycle
Under this item the individual positioning steps are listed
with common positioning examples.
ATTENTION!
The steps of the positioning process are dependent on the equipment
of the respective sewing unit.
Thus, the positioning steps described in the examples only apply for
sewing units with equal equipment.
Caution: Danger of injury!
Do not reach under the downholder, the feeding clamp and the folder
during the positioning process.
Remarks
Piped pockets,
manual positioning of piping strip,
flaps and other additional parts
Piped pockets,
automatic feed of the piping strip,
with/without incision of the piping ends
optional automatic feed of flap
and additional parts from the right
or from the left or both sides
Breast welt pockets,
automatic feed and matching
of the breast welt, automatic feed of the
pocket bag
Piped pockets,
automatic feed of piping strip
and additional parts,
automatic matching and feed
of the flap,
with/without incision of the piping end
1
33
Advertisement
Table of Contents
