Inserting the reinforcement strip
–
Press the wire clamp 1 together.
–
Pull off the disc 2 and remove the empty roll.
–
Insert a new roll.
The full roll must rotate in the indicated arrow direction when
unwinding (counter-clockwise).
–
Guide the reinforcement strip 5 through the wire bow 11.
–
Guide the reinforcement strip 5 through the wire bow of the tape
puller 3.
–
Guide the reinforcement strip sequentially through the guides 4
and 6.
–
Swivel the fabric sliding sheets 7 and 8 aside.
–
Press the slide 9 backwards and lift off the cover 10.
–
Press the key "F4".
The tape brake is released and the reinforcement strip is advanced
continuously.
–
Insert the reinforcement strip in the feeding device according to the
sketch.
–
Transport the reinforcement strip approx. 20 mm on the fabric
sliding sheet for the first working cycle.
–
Swivel the fabric sliding sheets 7 and 8 back again.
–
Press the key "F4".
The reinforcement strip is cut to the correct length.
Function and operation
–
The tape puller pulls a short length of the reinforcement strip from
the roll.
–
Before the next sewing cycle the transport roller of the feeding
device advances the reinforcement strip a little.
–
When sewing the pocket opening the reinforcement strip is seized
and sewn in according to the set sewing length.
–
At the seam end the reinforcement strip is cut off automatically.
–
The tape projection at the seam beginning and seam end can be
set in the menu item "Pocket parameters".
(See Programming Instructions, chapter 6.4)
1
79