Table of Contents
Advertisement
CE sign
This device is approved for the connection and use within the analogue public tele-
phone networks in all EC countries – according to the European Requirements. Due
to technical deviations in individual countries, we cannot grant an unlimited guaran-
tee for the successful operation at all types of telephone accesses.
Tiptel.com GmbH hereby declares that the device complies with all fundamental
requirements of the European directive 1999/5/EC. This conformity is confirmed by
the CE sign on the device.
Further details on the declaration of conformity can be found under the following
internet address:
http://www.tiptel.com
Troubleshooting
Power failure
The device is not operational during a power failure. The internal clock stops. But all
settings are retained so that the previous status is reset when power returns. You
may need to reset the time.
Using the following table try to define the cause of a problem and solve the error.
Problem
No display.
Display too weak or dark.
No sound.
OGM symbol flashing.
No answer, no monitoring.
No response in PABX.
Buzzing or other interference
on loudspeaker.
Messages not recorded.
No answer, subsequent
Appendix
Possible cause
No contact with mains power
supply.
Contrast set incorrectly.
Volume set to zero.
No OGM recorded.
No contact with connection
cable.
No call signal switched on.
Interference from cordless
telephone, monitor etc.
Device is set to OGM without
ICM option (message only).
Wrong connection cable,
89
Remedy/Recommendation
Check all cables and plugs. If
necessary try another plug.
Set contrast.
Adjust volume.
Record an outgoing message.
Check all cables and plugs.
Check PABX programming.
Chang installation location.
Change or re-record OGM.
Only use original cables, check
Advertisement
Table of Contents
