Section 1: Approvals And Codes; Approval Listings And Codes; Appliance Certification; Installation Codes - Heat-N-Glo SL-36 Installer's Manual

1
Approvals
and Codes
1
Approval Listings
and Codes
MODEL LABORATORY
SL-36 Underwriters
Laboratories
SL-36GDV Underwriters
Laboratories
SL-32S Underwriters
Laboratories
SL-32 Underwriters
Laboratories
SL-32GDV Underwriters
Laboratories

Installation Codes

The fireplace installation must conform to local codes. Before installing the
fireplace, consult the local building code agency to ensure that you are in
compliance with all applicable codes, including permits and inspections.
In the absence of local codes, the fireplace installation must conform to the
National Fuel Gas Code ANSI Z223.1 (in the United States) or the CAN/CGA-
B149 Installation Codes (in Canada). The appliance must be electrically
grounded in accordance with local codes or, in the absence of local codes with
the National Electric Code ANSI/NFPA No. 70 (in the United States), or to the
CSA C22.1Canadian Electric Code (in Canada).
These models may be installed in a bedroom or bed-sitting room in the U.S.A.
and Canada.

Appliance Certification

The Heat-N-Glo fireplace models discussed in this
Installers Guide have been tested to certification
standards and listed by the applicable laboratories.
TYPE
Direct Vent
Decorative
Direct Vent
Decorative
Direct Vent
Wall Furnace
Direct Vent
Decorative
Direct Vent
Decorative
CERTIFICATION
STANDARD
ANSI
Z21.50•CGA2.22
ANSI
Z21.50•CGA2.22
ANSI
Z21.88/CSA2.33
ANSI
Z21.50•CGA2.22
ANSI
Z21.50•CGA2.22