Control Board Settings; Dip Switches - Mighty Mule Silver-HD Dual 25th annivesary series Installation Manual

CONTROL BOARD SETTINGS

DIP Switches

DIP Switch Settings (MODES)
DIP Switch #1 - Soft Start/Stop
ON - Soft start enabled (factory preset).
OFF - Soft start disabled.
The Soft Start/Stop feature slowly starts the gate
as it begins to open and slows the gate as it comes
to the closed position. This saves wear and tear on
the gate and gate opener system.
DIP Switch #2 - Warning Buzzer
ON - Buzzer warning enabled (factory preset).
OFF - Buzzer warning disabled.
The Warning Buzzer alerts you when the gate
opener is beginning to either open or close the
gate. It sounds for the first 2 seconds in each
direction. It also sounds a warning when the gate
obstructs two times in one cycle. Switching this to
OFF disables the open and close warning not the
obstruction warning.
DIP Switch #3 - Push/Pull-to-Open
ON - Push to open.
OFF - Pull to open (factory preset).
If your gate opens into the property the DIP
Switch is set to the OFF position (factory setting).
If your gate opens out from the property the DIP
Switch must be set to the ON position. NOTE:
if you have a Push-to-Open gate application you
will need a Push-to-Open bracket (see Push-to-
Open Instructions on page 30).
DIP Switch #4 - Delay/Simultaneous operation
ON - Second opens simultaneously with master.
OFF - Second opens after master (factory preset).
Auto Close
The 'AUTO CLOSE TIME' pot controls
auto close feature.
Turning the pot all the way counter-clockwise
will turn auto close feature off. The minimum
time is 3 seconds. The maximum (turn the pot
all the way clockwise) time is 120 seconds.
Auto Close Time Pot
AUTO CLOSE TIME AUTO CLOSE TIME
OFF OFF
SOFT START OFF SOFT START OFF SOFT START OFF
WARNING WARNING WARNING OFF OFF OFF
OPEN OPEN OPEN PULL PULL PULL
2ND OPEN 2ND OPEN 2ND OPEN DLY. DLY. DLY.
MODE1 MODE1 MODE1 OFF OFF OFF
MODE2 MODE2 MODE2 OFF OFF OFF
AUTO CLOSE TIME
OFF 120
SOFT START OFF
WARNING OFF
OPEN PULL
2ND OPEN DLY.
MODE1 OFF
MODE2 OFF
24
STALL FORCE STALL FORCE
STATUS STATUS
LEARN RMT LEARN RMT
120 120 120 MIN MIN MIN MAX MAX
ON ON ON
ON ON ON
LEARN LEARN
PUSH PUSH PUSH
MAST LIMIT MAST LIMIT
SIMULT. SIMULT. SIMULT.
ON ON ON
ON ON ON
LEARN LEARN
2ND LIMIT 2ND LIMIT
STALL FORCE
STATUS
LEARN RMT
MIN MAX
ON
ON
LEARN
PUSH
MAST LIMIT
SIMULT.
ON
ON
LEARN
S3 S3
S2 S2
S4 S4
S3
S2