Downloading Firmware - IBM TotalStorage SAN16M-R SAN Installation And Service Manual

Downloading firmware

6. Activate the primary partition (location 1) and reboot the SAN
Router.
7. Upgrade the secondary partition (location 2) with the desired
image.
ATTENTION! Please ensure that you have gone through the
for upgrading firmware (4.6/4.7 to 5.0)
version before you start downloading the firmware to avoid any irreversible
change to the SAN Router settings.
The SAN Router can store up to two versions of firmware – the
currently active version and an inactive version. You can also
download the boot ROM.
You can use the CLI or Element Manager to download and install a
new version of firmware for the SAN Router. To download firmware
using the CLI, refer to the
Manual.The following instructions are for using the Element Manger.
Go to the website support section at
http://www.NishanSystems.com
support information.
To download firmware, follow these instructions:
NOTE: If you encounter any problems downloading the firmware, make sure
you have the latest version of the TFTP server installed. You can download
and install the latest version of the TFTP server from
http://www.solarwinds.com.
1. Select File>Firmware Upgrade.
The Firmware Upgrade dialog box displays.
and Checklist for migrating to 5.0
E/OSi Command Line Interface User
for the latest release notes and
Chapter 3: Maintenance and troubleshooting
Requirements
43