Upgrading Bootrom (E/Osi); San Router E/Osi And Bootrom Versions - IBM TotalStorage SAN16M-R SAN Installation And Service Manual

Upgrading bootrom (E/OSi)

46 SAN16M-R SAN Router Installation And Service Manual
5. Close and restart the web browser to load the new Element
Manager from the new version. After resetting the SAN Router,
the SAN Router's embedded web server may take 2 or 3 minutes
to become active.
You may need to upgrade the bootrom if the version is installed on
the SAN Router does not match the installed E/OSi firmware. You
can use the CLI or Element Manager to download and install
bootrom to the SAN Router. The following instructions are for using
the Element Manager. To download using the CLI, refer to the
Command Line Interface User
Go to the website support section at
http://www.NishanSystems.com for the latest release notes and
support information. Or contact your IBM representative for
assistance.
1. To determine if the bootrom installed on your system requires an
upgrade:
• Select Configuration/System/Properties to display the System
Properties dialog box. Check the version number in the Boot
ROM version field.
• Compare the bootrom version number to the bootrom version
in Table 17 for the E/OSi firmware installed on your SAN
Router.
Table 17

SAN Router E/OSi and bootrom versions

E/OSi Version bootrom Version
4.6 v1.0.3
4.7 v1.0.3
5.0 v1.0.5
2. If you need to upgrade the bootrom to match your current E/OSI
firmware, select File>Firmware Upgrade.
The Firmware Upgrade dialog box displays
Manual.
bootrom File Name
ECP3k103bootrom.bin
ECP3k103bootrom.bin
ECP3k105bootrom.bin
(Figure 10
E/OSi
on page 44).