Chapter 5 Removal And Replacement Procedures; Procedural Notes; Rrp 1: Sfp Optical Transceiver - IBM TotalStorage SAN16M-R SAN Installation And Service Manual

Chapter 5: Removal and replacement procedures

Procedural notes

RRP 1: SFP optical transceiver

© Copyright IBM Corp. 2007
Use the links below to access the major topics in this chapter.
Section
Procedural notes
RRP 1: SFP optical transceiver
RRP 2: Redundant power supply
The following procedural notes are referenced in applicable removal
and replacement procedures.
1. Before removing a FRU, read the removal and replacement
procedures for that FRU carefully and thoroughly to familiarize
yourself with the procedures and reduce the possibility of
problems or customer down time.
2. After completing steps of a detailed procedure that is referenced
from another procedure, return to the initial (referencing)
procedure and continue to the next step of that procedure.
3. After completing a replacement procedure, clear any error
messages reporting the failure and any message reporting the
recovery from the Element Manager or SANvergence Manager
and extinguish the system error (SYS) light-emitting diode (LED)
at the front panel.
Small form factor pluggable (SFP) optical transceivers are removed
and replaced while the router is powered on and operational.
Use the following procedures to remove or replace an SFP optical
transceiver from the front of the router chassis. Refer to
catalog, for FRU locations and part numbers.
Parts
Page
69
69
72
Chapter 4,
69