PSG -2000 Installation And Operating Instructions Manual page 36

MAINTENANCE:
WARNING: Turn off electric power supply before servicing the unit.
1. The furnace, the burner and the flue pipe should be cleaned at least once a year.
2. The nozzle should be inspected and replaced if needed.
Handle with care to avoid damaging its surface.
3. The electrodes should be adjusted as indicated in the burner manual.
4. Lubricate the burner motor bearings twice a year.
(2 or 3 drops of SAE 20 non detergent lubricating oil).
5. The oil filter should be replaced at least once a year.
Burner no.: _______________ Model: __________ Date of installation: _____________________
Service Telephone no.: Day: ______________________ Night: ___________________________
Dealer's name and address: _______________________________________________________
TEST REPORT :
CO _______% Temp. at stack: ______________ Draft at stack: ________w.c.
2
Nozzle output: _______________GPH
Inspected by : _______________________________________________________
FILTERS
The furnace should never be operated without filters.
This applies especially to temporary heating during construction period. Operating the furnace without filters
would allow dust and other particles in the air to circulate freely and to penetrate into the fans and motors
carters causing damage and possible failure. Clean and replace filters as often as required.
Note : The operation cost is higher and efficiency lower when using a dirty filter.
Smoke colour: ______________________
36