Installation Of Release Material; Installation Of Vapor Shield - Garland MWE3W Service Manual

GARLAND CLAMSHELL GRILLS WITH PRODUCT RECOGNITION

INSTALLATION OF RELEASE MATERIAL

1. Slide release material rod through hemmed end of the
release material sheet.
2. Hook release
material rod on
brackets located
at the rear of the
upper platen.
3. Holding the
bottom of the
"Teflon Sheet" available from your DC
release material
Saint Gobain: DC WRIN # 02180-003
Taconic: DC WRIN # 02180-000
sheet in place,
gently pull the
sheet toward the front of the platen.
NOTE: Make sure release material fits smoothly over upper
platen.
4. Place one (1)
locking clip over
release material
sheet in front
UPPER
PLATEN
and press into
(SIDE VIEW)
place over release
material bar.
5. Gently pull the
release material
sheet flap over
the left side of the
platen and secure in place with two (2) locking clips.

INSTALLATION OF VAPOR SHIELD

TEFLON
FRONT
BAR
PART #4526396 (03/30/10)
HEMMED
LOOP
MATERIAL
ROD
RELEASE
MATERIAL
RELEASE
MATERIAL
MATERIAL
ROD
MATERIAL ROD
HOLDER
6. Repeat step 5
RELEASE
with the right
MATERIAL
side. FLAPS
NOTE: Failure to
install the correct
number of clips on
the upper platen
will cause the
release material to
be loose, and wear
quickly. Ensure the
correct placement
of ALL clips to
prevent premature
wear and/or poor
product quality.
5. Check
alignment and
rightness of
release material
against upper
platen.
VAPOR SHIELD
UP & OVER
TEFLON
FRONT BAR
SERVICE MANUAL
RELEASE
MATERIAL
FLAPS
RELEASE
MATERIAL
CLIPS
Page 19