Installation Of Release Material - Garland MWE3W Installation And Operation Manual

INSTALLATION/OPERATION MANUAL

INSTALLATION OF RELEASE MATERIAL

1. Slide release material rod through hemmed end of the
release material sheet.
MATERIAL
ROD
RELEASE
MATERIAL
"Teflon Sheet" available from your DC
Saint Gobain: DC WRIN # XXXXX
Taconic: DC WRIN # XXXXX8
2. Hook release material rod on brackets located at the
rear of the upper platen.
UPPER
PLATEN
(SIDE VIEW)
RELEASE
MATERIAL
MATERIAL ROD
HOLDER
3. Holding the bottom of the release material sheet in
place, gently pull the sheet toward the front of the
platen.
NOTE: Make sure release material fi ts smoothly over upper
platen.
Page 18
HEMMED
LOOP
MATERIAL
ROD
GARLAND CLAMSHELL GRILLS WITH PRODUCT RECOGNITION
RELEASE
MATERIAL
FLAPS
4. Place fi ve (5) locking clips over release material sheet
and press into place over release material bar (2 ea
sides, 1 front center).
NOTE: Failure to install the correct number of clips on the
upper platen will cause the release material to be loose,
and wear quickly. Ensure the correct placement of ALL
clips to prevent premature wear and/or poor product
quality.
5. Check alignment and rightness of release material
against upper platen.
RELEASE
MATERIAL
FLAPS
RELEASE
MATERIAL
CLIPS
PART #4521777 (08/18/09)