Use the
) instance to configure Fast Ethernet (fe), Giga Ehternet (ge), StaticAggregate interface
(config-if
(sa), VLAN and tunnel . Use the
12.1 Interface Config commands
Table 12.1
summarizes the
config-if
Command
clrscr
Clears the display screen.
description
Interface specific description.
duplex
Defines the duplex mode of operation.
end
Ends the current mode and moves to the EXEC mode.
exit
Ends the current mode and moves down to the previous mode.
help
Describes the interactive help system.
ip
Configures an IP address for the assigned Ethernet, VLAN or tunnel.
mac
MAC interface commands to configure MAC access list to a gigabit
ethernet interface.
management
Sets the selected interface as the management interface.
mtu
Sets the mtu value for the VLAN interface.
(config)# interface [fe|ge|sa|tunnel|vlan]
commands.
Table 12.1 Interface Config Command Summary
Description
Interface Instance
to reach this instance.
Ref.
page 12-3
page 12-4
page 12-5
page 12-6
page 12-7
page 12-8
page 12-9
page 12-11
page 12-12
page 12-13