Motorola RFS7000 Series Reference Manual page 568

20-64 Overview
secure-beacon
set-vlan-user-limit
[<1-4094>|VLAN]
ssid
syslog (accounting)
server <IP Address>
port <Port number>
vlan<1-4094> [limit range]
• server timeout<1-300> retransmit<1-100> – Modify RADIUS/802.1X
server parameters.
• timeout<1-300> – Time, in seconds, the switch waits for a response
from the RADIUS server before retrying.
• retransmit<1-100> – Number of retries before the switch gives up
and disassociates the mobile unit.
Note The
RFS7000(config-wireless)# radius server
timeout<*> retransmit<*>
defined for an MU's timeout and retries. If the MU's time is less
than the server's, a fallback to the secondary server will not work.
Do not include the SSID of this WLAN in Beacon frames.
Sets user limits on vlans for this WLAN.
• [<1-4094>|VLAN] – VLAN range list. It can be either a single index or a
list (eg: 1,3,7) or range (eg: 3-7) of indices.
The SSID of this WLAN.
Syslog Accounting.
• accounting – Modifies accounting parameters.
• server <IP Address> – Modifies syslog accounting server IP address.
• port <Port Number> – Syslog server port. The default port is 514.
The VLAN assignment of this WLAN. This command starts a new VLAN
assignment for given WLAN index. All prior VLAN settings will be erased.
• [<1-4094>|VLAN] – VLAN range list. It can be either a single index or a
list (eg: 1,3,7) or range (eg: 3-7) of indices.
• limit – Set user limits on vlans for this WLAN.
should be less than what is