19.1.15 service
RADIUS Configuration Commands
Use this command to invoke service commands to trobuleshoot or debug
configurations. This command is also used to enable the RADIUS Server.
Syntax
service (show) (cli)
Parameters
show (cli)
Example
RFS7000(config-radsrv)#service show cli
Radius Configuration mode:
+-authentication
+-data-source
+-ldap [authentication data-source (local|ldap)]
+-local [authentication data-source (local|ldap)]
+-eap-auth-type
+-all [authentication eap-auth-type (ttls-md5|ttls-pap|ttls-mschapv2|peap-
gtc|peap-mschapv2|tls|all)]
+-peap-gtc [authentication eap-auth-type (ttls-md5|ttls-pap|ttls-
mschapv2|peap-gtc|peap-mschapv2|tls|all)]
+-peap-mschapv2 [authentication eap-auth-type (ttls-md5|ttls-pap|ttls-
mschapv2|peap-gtc|peap-mschapv2|tls|all)]
+-tls [authentication eap-auth-type (ttls-md5|ttls-pap|ttls-mschapv2|peap-
gtc|peap-mschapv2|tls|all)]
+-ttls-md5 [authentication eap-auth-type (ttls-md5|ttls-pap|ttls-
mschapv2|peap-gtc|peap-mschapv2|tls|all)]
+-ttls-mschapv2 [authentication eap-auth-type (ttls-md5|ttls-pap|ttls-
mschapv2|peap-gtc|peap-mschapv2|tls|all)]
+-ttls-pap [authentication eap-auth-type (ttls-md5|ttls-pap|ttls-
mschapv2|peap-gtc|peap-mschapv2|tls|all)]
+-ca
+-trust-point
+-WORD [ca trust-point WORD]
+-clrscr [clrscr]
+-crl-check
+-enable [crl-check enable]
+-do
+-LINE [do LINE]
+-end [end]
+-exit [exit]
+-group
+-WORD [group WORD]
+-help [help]
+-ldap-server
+-primary
+-host
+-A.B.C.D
+-port
+-<1-65535>
+-login
+-WORD
+-bind-dn
.................................................................................
.................................................................................
RFS7000(config-radsrv)#
Shows running system information.
instance
(config-radsrv)
19-27