Vpn Tunnel Configuration; How To Set Up A Client-To-Gateway Vpn Configuration - NETGEAR ProSafe FVG318 Reference Manual

Reference Manual for the ProSafe Wireless 802.11g VPN Firewall Model FVG318
Note: NETGEAR publishes additional interoperability scenarios with various gateway
and client software products.

VPN Tunnel Configuration

There are two tunnel configurations and three ways to configure them:
• Use the VPN Wizard to configure a VPN tunnel (recommended for most situations):
— See "How to Set Up a Client-to-Gateway VPN Configuration" on page
— See "How to Set Up a Gateway-to-Gateway VPN Configuration" on page
• See Chapter 7, "Advanced Virtual Private
defaults (see Table 6-1

How to Set Up a Client-to-Gateway VPN Configuration

Setting up a VPN between a remote PC running the NETGEAR ProSafe VPN Client and a
network gateway (see figure below) involves the following two steps:
• "Step 1: Configuring the Client-to-Gateway VPN Tunnel on the FVG318" on page 6-6
the VPN Wizard to configure the VPN tunnel between the remote PC and network gateway.
Basic Virtual Private Networking
Networking" when the VPN Wizard and its VPNC
on page 6-4) are not appropriate for your special circumstances.
v1.0, October 2005
6-5.
6-22.
uses
6-5