Gathering The Network Information; Configuring The Gateways - NETGEAR ProSafe FVG318 Reference Manual

Reference Manual for the ProSafe Wireless 802.11g VPN Firewall Model FVG318

Gathering the Network Information

The configuration in this document follows the addressing and configuration mechanics defined
by the VPN Consortium. Gather all the necessary information before you begin the configuration
process. Verify whether the firmware is up to date, all of the addresses that will be necessary, and
all of the parameters that need to be set on both sides. Check that there are no firewall restrictions.
10.5.6.0/24
Gateway A
LAN IP
10.5.6.1
Figure B-1

Configuring the Gateways

Configure each gateway as summarized in
1. Configure Gate A.
a. Log in to the router at Gateway A.
b. Use the VPN Wizard to configure this router.
Enter the requested information as prompted by the VPN Wizard:
• Connection Name and Pre-Shared Key
• Remote WAN IP address
• Remote LAN IP Subnet: IP Address and Subnet Mask:
2. Repeat the above steps for Gateway B.
a. Log in to the router at Gateway B.
b. Use the VPN Wizard to configure this router.
C-2
VPN Consortium Example
Network Interface Addressing
14.15.16.17 22.23.24.25
WAN IP WAN IP
Figure B-2
v1.0, October 2005
Gateway B
LAN IP
172.23.9.1
and Figure B-3:
VPN Configuration of NETGEAR FVG318
172.23.9.0/24