NETGEAR ProSafe FVG318 Reference Manual page 113

Reference Manual for the ProSafe Wireless 802.11g VPN Firewall Model FVG318
c. Type ping -t 192.168.3.1 and then click OK.
Figure 6-34
This will cause a continuous ping to be sent to the first FVG318. Within two minutes, the
ping response should change from "timed out" to "reply."
Note: Use Ctrl-C to stop the pinging.
Figure 6-35
Once the connection is established, you can open the browser of the PC and enter the LAN IP
address of the remote FVG318. After a short wait, you should see the login screen of the
Wireless VPN Firewall (unless another PC already has the FVG318 management interface
open).
• Gateway-to-Gateway Configuration—test the VPN tunnel by pinging the remote network
from a PC attached to the FVG318.
a. Open a command prompt (Start -> Run -> cmd).
Basic Virtual Private Networking
v1.0, October 2005
6-31