NETGEAR ProSafe FVG318 Reference Manual page 195

Reference Manual for the ProSafe Wireless 802.11g VPN Firewall Model FVG318
a. Right-mouse-click the ProSafe icon (
Editor. If you need to install the NETGEAR ProSafe VPN Client on your PC, consult the
documentation that came with your software.
b. Add a new connection using the Edit/Add/Connection menu and rename it Scenario_1.
(Scenario_1 is used in this example to reflect the fact that the connection uses the Pre-
Shared Key security scheme and encryption parameters proposed by the VPN
Consortium, but you may want to choose a name for your connection that is meaningful to
your specific installation. The name you choose does not have to match the name used at
the gateway end of the VPN tunnel.)
Figure B-14
c. Program the Scenario_1 connection screen as follows (see
• Connection Security: Secure
• Remote Party Identity and Addressing: Select IP Subnet from the ID Type menu and
then enter 10.5.6.1 for Subnet, 255.255.255.0 for Mask, and leave All for Protocol.
(The Subnet and Mask parameters entered here must match the Start IP address and
Subnet Mask parameters of the Local IP Traffic Selector on the VPN Autopolicy
screen shown in
• Enable Connect Using Secure Gateway Tunnel; select Domain Name for ID_Type;
enter fvs_local for Domain Name; and enter 14.15.16.17 for Gateway IP Address.
(Domain Name must match the Local Identity Data parameter of the IKE Policy
Configuration screen shown in
IP Address must match the WAN IP address of the gateway router shown in
Figure B-11.)
VPN Configuration of NETGEAR FVG318
) in the system tray and select the Security Policy
Figure B-13 for the gateway router.)
Figure B-13
v1.0, October 2005
Figure B-15 on page
for the gateway router. Also, Gateway
B-20):
C-19