NETGEAR ProSafe FVG318 Reference Manual page 148

Reference Manual for the ProSafe Wireless 802.11g VPN Firewall Model FVG318
This screen shows the following parameters:
Table 8-1. FVG318 Status fields
Field
System Name
Firmware Version
WAN Port
MAC Address
IP Address
IP Subnet Mask
DHCP
LAN Port
MAC Address
IP Address
IP Subnet Mask
DHCP
Click Connection Status to display the WAN connection status.
Figure 8-2
8-2
Description
The System Name assigned to the firewall.
The firewall firmware version.
These parameters apply to the Internet (WAN) port of the firewall.
The MAC address used by the Internet (WAN) port of the firewall.
The IP address used by the Internet (WAN) port of the firewall. If no address is
shown, the firewall cannot connect to the Internet.
The IP Subnet Mask being used by the Internet (WAN) port of the firewall.
The protocol on the WAN port used to obtain the WAN IP address. This field can
show DHCP Client, Fixed IP, PPPoE, BPA or PPTP. For example, if set to Client,
the firewall is configured to obtain an IP address dynamically from the ISP.
These parameters apply to the Local (WAN) port of the firewall.
The MAC address used by the LAN port of the firewall.
The IP address used by the Local (LAN) port of the firewall. The default is
192.168.1.1
The IP Subnet Mask used by the Local (LAN) port of the firewall. The default is
255.255.255.0
Identifies if the firewall's built-in DHCP server is active for the LAN attached
devices.
v1.0, October 2005
Maintenance