Setting Tag Channels; Starting A Scan - Icom IC-M90 Instruction Manual

■ Setting tag channels

For more efficient scanning, add desired channels as tag
channels or clear the tag for unwanted channels.
Non-tag channels will be skipped during scanning.
q Select the desired channel to set as a tag channel.
w Push both [Y] and [Z] for 1 sec. to set the displayed
channel as a tag channel.
• " " appears in the function display.
e To cancel the tag channel setting, push both [Y] and [Z]
for 1 sec.
• " " disappears.
✔ Clearing all tag channels in the selected channel group
While pushing and holding both [Y] and [Z], turn power ON
to clear all tag channels in the channel group.
[Example]: Starting a normal scan.
Push Scan starts.
for 1 sec.

■ Starting a scan

Set the weather alert function, priority scan function, scan
resume timer and auto scan function in advance, using the
SET mode. (pgs. 17, 18)
q Select the desired channel group (USA, CAN, INT) by
pushing
[CH/WX• ] for 1 sec.
U/I/C/L
• When the weather alert function is in use, select the desired
weather channel with [CH/WX•
w Push
to start priority or normal scan.
[SCAN• ]
DUAL
• "SCAN" blinks in the function display.
• "16" appears on the sub channel readout during priority scan.
• When a signal is received, scan pauses until the signal dis-
appears or resumes after pausing 5 sec. according to scan
resume timer setting. (Channel 16 is still monitored during prior-
ity scan.)
• Push [Y]/[Z] to check the scanning tag channels, change the
scanning direction or resume the scan manually.
e To stop the scan, push
[SCAN•
• "SCAN" disappears.
• Pushing [PTT], [16• ] or [CH/WX•
9
Receiving a signal
and audio is emitted.
SCAN OPERATION
, if desired.
] and [Y]/[Z].
U/I/C/L
.
]
DUAL
] also stops the scan.
U/I/C/L
Push
to stop the scan
5
5
13